Hello, on the 3750, try to use the channel-group 1 mode on.
On the SGE2010 switch, create a static LAG without LACP.
Once you configure the channel groups you can make the interface type (trunk, access, etc) to match the traffic you want it to pass.
I recommend only to use manual lag on the 3750 connecting to any of the small business switches since the LAG configuration is quite limited comparing to the larger counterparts. If there is not an exact setting for both devices, the 3750 will loop the downstream switch.
Please mark answered for helpful posts
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.