Right now we have the problem, that SFP-10G-LR are not working on Cisco 3650 10G Ports - IOS XE 3.3.0SE (see TE1/1/3 and picture in attachment). Which is really strange, becuase in the compatability matrix and in the datasheet this Module is supported. What is also strange is, that not orginial Cisco SFP+ LR Transceivers are working (see TE1/1/4)
*Mar 20 09:15:07: %PLATFORM_PM-6-MODULE_ERRDISABLE: The inserted SFP module with interface name Te1/1/3 is not supported
*Mar 20 09:15:07: %PM-4-ERR_DISABLE: gbic-invalid error detected on Te1/1/3, putting Te1/1/3 in err-disable state
Te1/1/3 to CSAARAWA01, Te1 err-disabled 1 auto auto unknown
Te1/1/4 to GSAARKLBEG02, T notconnect 1 full 10G SFP-10GBase-LR
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...