Hi, quick question - are the SFP-10GBase-SR modules or is it SFP-10GBase-SR+ that we use in our 2960x and 3750xs compatible with 3850xs?
TenGigabitEthernet1/0/1 is up, line protocol is up (connected) Hardware is Ten Gigabit Ethernet, address is 44e4.d948.3233 (bia 44e4.d948.3233) Description: UPLINK NAS-10G-CORE-SW1 | Eth1/6 MTU 1500 bytes, BW 10000000 Kbit/sec, DLY 10 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive not set Full-duplex, 10Gb/s, link type is auto, media type is SFP-10GBase-SR
The 3850 switches were shipped with 3.2.0SE by default some time back. I am not sure if the factory installed version has changed recently. However, our suggestion is to use 3.3.2 (stable release) as major bugs have been fixed starting from this IOS version.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...