I currently have WS-C2950SX-24 and we are migrating to WS-C2960-24TC-S a recomended replacement from Cisco in its EOL/EOS notification. The migration is in three phases where in first phase we only eliminate 20 switches whereas the remaining 80 will work as previous. Here in 2950-SX we have two integrated sx ports where 2960 we have sfp ports. I have done my research and found that GLC-SX-MM is the right replacement (Thats my perspective) but the connecting patch cords for fiber i was using is not compatible with GLC-SX-MM. Kindly suggest whether its a compatibility issue or if i can change the patch cords it will work for me.
(Briefly, keep the 2950 connector type on one end and replace the other end connector type with the one compatible with GLC-SX-MM ??????)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...