Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SFP Detail Diagnostics Information Nexus 7000

Hello guys,

I have a question about why one port on a Nexus 7000 with a N7K-M132XP-12 (32 port 10G card) doesn't show any values
when looking at "show inter e 9/27 transceiver details", all values are just zero.

N7K# show inter e 9/27 transceiver details
Ethernet9/27
 transceiver is present
 type is 10Gbase-SR
 name is CISCO-EXCELIGHT
 part number is SPP5101SR-C1
 revision is A
 serial number is EXX13050136
 nominal bitrate is 10300 MBit/sec
 Link length supported for 50/125um OM2 fiber is 82 m
 Link length supported for 62.5/125um fiber is 26 m
 Link length supported for 50/125um OM3 fiber is 300 m
 cisco id is --
 cisco extended id number is 4
 number of lanes 1

 SFP Detail Diagnostics Information (internal calibration)
 ----------------------------------------------------------------------------
 Current Alarms Warnings
 Measurement High Low High Low
 ----------------------------------------------------------------------------
 Temperature N/A 0.00 C 0.00 C 0.00 C 0.00 C
 Voltage N/A 0.00 V 0.00 V 0.00 V 0.00 V
 Current N/A 0.00 mA 0.00 mA 0.00 mA 0.00 mA
 Tx Power N/A 0.00 dBm 0.00 dBm 0.00 dBm 0.00 dBm
 Rx Power N/A 0.00 dBm 0.00 dBm 0.00 dBm 0.00 dBm
 Transmit Fault Count = 2
 ----------------------------------------------------------------------------
 Note: ++ high-alarm; + high-warning; -- low-alarm; - low-warning

Tried to remove the SFT+ and inserted a new, but same results, all values are 0.
Does anyone know why it doesn't show any values?


We are runing version 6.2(8)
And here's the port configuration:

interface Ethernet9/27
 switchport
 switchport mode trunk
 spanning-tree port type edge trunk

499
Views
0
Helpful
0
Replies