Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SFP port isn't up after the system reset

I have two switches Cisco 6500

 

one side have a supervisor 720 with CATOS version 8.6(5) and the other side have a supervisor 32 with IOS release 12.2(4)15a.

 

 

the switch with the supervisor 720 have configured UDLD enabled and the supervisor 32 side have not.

 

when i reset the supervisor 32 side, the SFP port in that switch is not up. in the supervisor 720 the port joins in error disable state, altough the port is not configured for aggresive mode.

 

i was need to unplug the SFP module in the switch with the supervisor 32 to recover the link.

 

any explanation about this issue?

 

 

 

1 REPLY
New Member

Re: SFP port isn't up after the system reset

999
Views
0
Helpful
1
Replies