04-07-2017 11:45 PM - edited 03-08-2019 10:07 AM
Hi,
When i configure my 4500 series switch with redundant supervisor engine SUP-8E (in case of 4507R+E & 4510R+E) then how many SFP+ ports i can used? can i use all 16 ports as 10GE SFP+ or 4 ports in supervisor-1 and 4 ports in supervisor-2?
Thanks.
04-08-2017 02:44 PM
Hi,
See table-2 in this link.
In dual sup mode, you can use 4x10 10Gig (SFP+) from each sup. There is no restriction on the 7 slot chassis but on the 10 slot chassis, the last slot needs to be 47XX series line card if you are going to be using it.
http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-4500-series-switches/data_sheet_c78-728191.html
BTW, Sup-8-E has been pretty solid sup so far.
HTH
04-10-2017 02:22 AM
Thanks Reza it was very helpful.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: