Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SFP+ ports can be used in Cisco 4500E switch when configure in redundant sup.

Hi,

When i configure my 4500 series switch with redundant supervisor engine SUP-8E (in case of 4507R+E & 4510R+E) then how many SFP+ ports i can used? can i use all 16 ports as 10GE SFP+ or 4 ports in supervisor-1 and 4 ports in supervisor-2?

Thanks.

2 REPLIES
VIP Super Bronze

Hi,

Hi,

See table-2 in this link.

In dual sup mode, you can use 4x10 10Gig (SFP+) from each sup.  There is no restriction on the 7 slot chassis but on the 10 slot chassis, the last slot needs to be 47XX series line card if you are going to be using it.

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-4500-series-switches/data_sheet_c78-728191.html

BTW, Sup-8-E has been pretty solid sup so far.

HTH

New Member

Thanks Reza it was very

Thanks Reza it was very helpful.

18
Views
0
Helpful
2
Replies
CreatePlease to create content