Just purchased this switch and it is in its default out of the box config. I want to make a second VLAN thats stand alone as a 'sandbox' if you will, for a Guest network. No traffic to pass between vlan1 and vlan2. I have created vlan2, added ports 1 - 6 to vlan2, tried modifying as untagged, and finally changed the port type from 'Trunk' to 'General' but still can not pass traffic or ping between ports 1 and 2. What havent I done, or what more must I do?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...