I have two sg300 52 ports switches, in each of them the last two ports formes a lag group with port-channel static mode in order to connect to each other with a higher bandwidth. In normal circumstances if i would connect two switch with two cabels then a loop created. If i use the port-channel with two ports on switch A and two ports on switch B, should I configure something related to spanning-tree?
thank you very much
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...