Hi, I need some help setting up VLAN on SG300 switch.
Here's the toplogy:
SG300 switch (VLAN1, and VLAN200)
ASA 5510 firewall
VLAN 1 - Interface IP: 192.168.1.5
VLAN 200 - Interface IP: 10.10.10.254
ASA 5510 - 192.168.1.253
Static route has been added on ASA 5510 and SG300
S 10.10.10.0 255.255.255.0 [5/0] via 192.168.1.5, inside
S 0.0.0.0/0 [1/1] via 192.168.1.253, 16:25:47, vlan 1
C 10.10.10.0/24 is directly connected, vlan 200
C 192.168.1.0/24 is directly connected, vlan 1
On the SG300, I have 1 port for VLAN 200 as accessport, VLAN 200 untagged, VLAN1 tagged.
I have one PC connected to VLAN 200, ip address: 10.10.10.10
Here's what I have so far:
- I can ping to the PC in VLAN 200 from any workstation in VLAN 1
- I can ping from the PC (10.10.10.10) in VLAN 200 to any workstation in VLAN 1
- I can browse the Internet by using google DNS 18.104.22.168
- I cannot get any data between the VLAN's. I have HTTP webserver on VLAN 1, and I cannot get to it from VLAN 200. I cannot get to my DNS server in VLAN 1. I cannot access any workstation from VLAN 1 either.
The fact that I can ping from the PC in VLAN 200 to PC's in VLAN 1 and vice versa indicates that the traffic is being routed through the VLAN's. But it is just very confusing that I'm unable to get any data across.
Any help would be very much appreciated!! Thanks in advance!!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...