04-24-2018 01:18 AM - edited 03-08-2019 02:46 PM
Hi,
have here a very strong behaviour, after pluging in a cable the switchport mode of a port is switched automatically to trunk (e.g. from general or access). How to disable it?
Thanks
Henri
Solved! Go to Solution.
04-24-2018 01:39 AM
Hi,
Disable "Smart switchport" setting for a port and check. What device are you going to connect?
Regards,
Deepak Kumar
04-24-2018 01:39 AM
Hi,
Disable "Smart switchport" setting for a port and check. What device are you going to connect?
Regards,
Deepak Kumar
05-02-2018 12:40 AM
Hi Deepak,
thanks a lot, this was most helpfull.
Best regards
Henri
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: