I recently bought 6 SGE2010 switches and was looking for some advice on getting them setup setup in my network. These will be the only switches in our corporate office so my first quoestion would be, should I stack them or leave them as stand alone switches? If I stack them I can only stack 4 since they are 48 port switches and it looks like I can only stack 192 ports. If I setup 2 stacks each with 144 ports how do the two stacks pass information? Sorry but I am a little confused as to how and why stacking would be a benifit. Any suggestions or advice would be greatly appreciated.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...