Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SGE2010P Jumbo Frames

Does anyone know where to configure Jumbo Frames on an SGE2010P, all the literature I read through says it supports them but I cannot for the life of me find where to configure it.

Any suggestions would be awesome

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

I hope that in the last two

I hope that in the last two years you were finally able to figure this out.  And/or this isn't a fishing expedition?  But I'm going to answer the question anyway.

The Jumbo Frames option on the SP2010P Switches can be found on the very first screen when logging into the web interface.

System> System Management> System Information

This is the default landing page after logging into the switch/stack.  There are two radio buttons, one for Stack and another, just below, for Jumbo Frames

1 REPLY
New Member

I hope that in the last two

I hope that in the last two years you were finally able to figure this out.  And/or this isn't a fishing expedition?  But I'm going to answer the question anyway.

The Jumbo Frames option on the SP2010P Switches can be found on the very first screen when logging into the web interface.

System> System Management> System Information

This is the default landing page after logging into the switch/stack.  There are two radio buttons, one for Stack and another, just below, for Jumbo Frames

399
Views
0
Helpful
1
Replies