Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

sh int s1/0 reliablity issue

Sh int s1/0

reliablity shows 224/255 it indicateds what?

3 REPLIES

Re: sh int s1/0 reliablity issue

Hi,

The reliability is the dependability of a network link. Some WAN links tend to go up and down throughout the day. These links get a small reliability rating.

Its a fraction of 255 (255/255 is 100% reliability), calculated as an exponential average over five minutes, and is based on keepalives.

Regards,

New Member

Re: sh int s1/0 reliablity issue

Suppose if the reliablity lower, is there any possiblity route different path.

Re: sh int s1/0 reliablity issue

Routing algorithms have used many different metrics to determine the best route. Sophisticated routing algorithms can base route selection on multiple metrics, combining them in a single (hybrid) metric. Metrics used for routing protocols are:

bandwidth, network delay, hop count, path cost, load, MTU, reliability, and communication cost.

OSPF can calculate cost on the basis of metrics such as link speed and reliability in addition to hop count.

EIGRP can also be configured to take the reliability into account when calculating the metric (only considers bandwidth and delay by default)

However, if you are using static routing, reliability will not have any influence on the routing table on your layer 3 devices.

Regards.

176
Views
10
Helpful
3
Replies
CreatePlease login to create content