Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

sh int summary parameters

does anybody can explain

what is that parameters of sh int summary command ?

SW4510-PJCAP#sh int SUMmary

*: interface is up

IHQ: pkts in input hold queue IQD: pkts dropped from input queue

OHQ: pkts in output hold queue OQD: pkts dropped from output queue

RXBS: rx rate (bits/sec) RXPS: rx rate (pkts/sec)

TXBS: tx rate (bits/sec) TXPS: tx rate (pkts/sec)

TRTL: throttle count

tks !

Antonio

2 REPLIES
Silver

Re: sh int summary parameters

Sh int command are following:

sh int s0, sh int, show int etc

For more command reference click following links:

http://networking.ringofsaturn.com/Cisco/ciscocommandguide.php

New Member

Re: sh int summary parameters

Tks Didyap,

But the parameters that i referred is :

- what is it ? - IHQ: pkts in input hold queue

- what is it ? - IQD: pkts dropped from input queue

- what is it ? - OHQ: pkts in output hold queue

- what is it ? - OQD: pkts dropped from output queue

- what is it ? - RXBS: rx rate (bits/sec)

- what is it ? - RXPS: rx rate (pkts/sec)

- what is it ? - TXBS: tx rate (bits/sec)

- what is it ? - TXPS: tx rate (pkts/sec)

- what is it ? - TRTL: throttle count

Tks

2858
Views
0
Helpful
2
Replies