Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

sh port-channel traffic

When I run sh port-channel traffic command, I get the following.  Most of these port channels are setup for ESX vm hosts, and I don't know what does it mean when it shows 100%. 

Is the interface associated with the port channel 100 utilized?

If I do a show interface e1/17, it doesn't show it maxed out, in fact it is < 1 mbps.

ChanId      Port Rx-Ucst Tx-Ucst Rx-Mcst Tx-Mcst Rx-Bcst Tx-Bcst

------ --------- ------- ------- ------- ------- ------- -------

     1   Eth1/31  52.96%  37.24%  38.20%  40.43%  18.11%  82.18%

     1   Eth1/32  47.03%  62.75%  61.79%  59.56%  81.88%  17.81%

------ --------- ------- ------- ------- ------- ------- -------

    10    Eth1/1  45.54%  30.48%  52.07%  63.67%  52.78%  32.59%

    10    Eth1/2  54.45%  69.51%  47.92%  36.32%  47.21%  67.40%

------ --------- ------- ------- ------- ------- ------- -------

   114   Eth1/17 100.00% 100.00% 100.00% 100.00% 100.00% 100.00%

------ --------- ------- ------- ------- ------- ------- -------

   115   Eth1/18 100.00% 100.00% 100.00% 100.00% 100.00% 100.00%

------ --------- ------- ------- ------- ------- ------- -------

   116   Eth1/19 100.00% 100.00% 100.00% 100.00% 100.00% 100.00%

------ --------- ------- ------- ------- ------- ------- -------

   117   Eth1/20 100.00% 100.00% 100.00% 100.00% 100.00% 100.00%

------ --------- ------- ------- ------- ------- ------- -------

   118   Eth1/21 100.00% 100.00% 100.00% 100.00% 100.00% 100.00%

------ --------- ------- ------- ------- ------- ------- -------

   119  Eth101/1/6 100.00% 100.00% 100.00% 100.00% 100.00% 100.00%

Everyone's tags (3)
348
Views
0
Helpful
0
Replies
CreatePlease to create content