Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Should IP accounting work on 3750 switch configured to route?

I have a 3750 that I'm using as a router:

"ip routing"

..and "no switchport" on the routing interfaces.

I added "ip accounting output-packets"

on both the interfaces setup for routing and ran a bunch of traffic through the device. But "show ip accounting" gives me nothing.

This seemed to work so easily on my 2821 router. Is there something about this being a switch that messes with accounting? Is there an alternative? Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: Should IP accounting work on 3750 switch configured to route

Sorry, ip accounting is not supported under Catalyst switches.

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_44_se/configuration/guide/swuncli.html#wp1060469

HTH,

__

Edison

Please rate helpful posts

2 REPLIES
Hall of Fame Super Bronze

Re: Should IP accounting work on 3750 switch configured to route

Sorry, ip accounting is not supported under Catalyst switches.

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_44_se/configuration/guide/swuncli.html#wp1060469

HTH,

__

Edison

Please rate helpful posts

New Member

Re: Should IP accounting work on 3750 switch configured to route

Thanks for the reply!

Too bad they can't remove unsupported commands.

406
Views
0
Helpful
2
Replies