Show Command to see RPVST+ details of all VLANs in CatOS?
I needed the show command to see the tree structure for all VLANs in CatOS switch running RPVST+. Please can someone help me with this? Below command gives only VLAN1, any single command to give the below details for all VLANs? Need it ASAP.
show spantree active
VLAN 1 Spanning tree mode RAPID-PVST+ Spanning tree type ieee Spanning tree enabled
Designated Root 00-09-11-3b-78-00 Designated Root Priority 8192 Designated Root Cost 1852 Designated Root Port 1/2,2/2 (agPort 14/1) Root Max Age 20 sec Hello Time 2 sec Forward Delay 15 sec
Bridge ID MAC ADDR 00-07-ec-6c-38-00 Bridge ID Priority 49152 Bridge Max Age 20 sec Hello Time 2 sec Forward Delay 15 sec
Port State Role Cost Prio Type ------------------------ ------------- ---- --------- ---- -------------------- 1/1,2/1 blocking ALTR 1851 32 P2P 1/2,2/2 forwarding ROOT 1851 32 P2P
Re: Show Command to see RPVST+ details of all VLANs in CatOS?
I could get following options for "show spantree ?" :
active Show active ports in spanning tree backbonefast Show spanning tree backbone fast blockedports Show ports that are blocked bpdu-filter Show spanning tree bpdu-filter information bpdu-guard Show spanning tree bpdu-guard information bpdu-skewing Show spanning tree bpdu skewing statistics conflicts Show spanning tree conflicting info for vlan debug Show spanning tree bpdu information defaultcostmode Show spanning tree port cost mode guard Show spanning tree guard info mapping Show spanning tree vlan and instance mapping mistp-instance Show spantree info for MISTP instance mst Show MST information portfast Show spanning tree port fast info portinstancecost Show spanning tree port instance cost portvlancost Show spanning tree port vlan cost statistics Show spanning tree statistic info summary Show spanning tree summary uplinkfast Show spanning tree uplink fast Module number and Port number(s) VLAN number for PVST+/RAPID-PVST+ | Output modifiers
I think such a command is not available :-( Let me know your views..yeah as u said i get only VLAN1 without any options...
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...