Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Show Command

I am trying to find this show command, which would give me Source and Destination ip address on a PTP link. It would also show me how much bandwidth they were using. Ideas?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Show Command

Daniel

If you have configured NetFlow on the interface then you could use the show ip cache flow and get source and destination address and bandwidth usage.

HTH

Rick

3 REPLIES
Hall of Fame Super Silver

Re: Show Command

Daniel

If you have configured NetFlow on the interface then you could use the show ip cache flow and get source and destination address and bandwidth usage.

HTH

Rick

New Member

Re: Show Command

Thanks that was it, what is the difference between 3694 and 76k for the packets category?

Hall of Fame Super Silver

Re: Show Command

Daniel

The packets category is a count of the number of packets. So someone transmitted 3694 packets and someone transmitted 76k packets.

HTH

Rick

293
Views
0
Helpful
3
Replies
CreatePlease to create content