Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Show Config Command options

I've got a 4507R that when I do "sho config" or "sho run" it outputs the entire configuration to the screen instead of one page at a time. Is there a way to fix this? Application buffer fills up and can't scoll up to what I need to see.

2 REPLIES
Hall of Fame Super Bronze

Re: Show Config Command options

Are you connected via the console to the redundant Supervisor? If so, that's an expected behavior. Connect to the active supervisor and the screen should stop one page at the time.

If that's not the case, then check your terminal settings.

Please post the output from typing show term

HTH,

__

Edison.

Blue

Re: Show Config Command options

JT:

At the privilege exec prompt (hostname#), type term len 30.

This will restrict the output to 30 lines at a time.

HTH

If so, please rate all helpful posts.

Victor

331
Views
7
Helpful
2
Replies
CreatePlease to create content