cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
28561
Views
0
Helpful
2
Replies

SHOW CONNECTIONS ON IOS

gcocchi
Level 1
Level 1

Hi, is there a command to show active connections that pass through 2 eth ports on cisco ios?

Thx.

2 Replies 2

graemeporter
Level 1
Level 1

Hi there,

You could try:

show ip cache flow

See if that does what you need.

Kind regards,

Graeme

Pavel Bykov
Level 5
Level 5

Also you could try enable accounting on the interface. It will not always display active connections since it's incremental (old connection stay in the list) but it can display what is flowing.

commands are:

(config-if)#ip accounting

#show ip accounting

#clear ip accounting (reset list)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: