Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Show diags link-flap

On the 2950 and 3500 series switches you can use the show diags link-flap command to see if a link has been flapping.

Is there a similar command on either the 3560 or 4507 to view the same statistics?

1 REPLY
Silver

Re: Show diags link-flap

This command is only supported in XL series switches. In other switches interface is put into the errdisabled state if it flaps more than five times in 10 seconds. You can determine if your port has been error disabled if you issue the show interfaces command.

257
Views
0
Helpful
1
Replies