Not that I know of and I think a lot of people would like that feature in all their switches. I also would like the same function in the 4500 and 6500 as say a 3750 or a 2960 which is the "show controllers utilization " command . This gives you an instant look at the utilization percentage on all ports along with the switch fabric utilization . Very useful but they don't put it in their modular boxes , might be a hardware restriction but it would be nice to have an equivalent for the modular boxes.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...