Not that I know of and I think a lot of people would like that feature in all their switches. I also would like the same function in the 4500 and 6500 as say a 3750 or a 2960 which is the "show controllers utilization " command . This gives you an instant look at the utilization percentage on all ports along with the switch fabric utilization . Very useful but they don't put it in their modular boxes , might be a hardware restriction but it would be nice to have an equivalent for the modular boxes.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...