I'm hoping this is an easy one. I have a WSx4232-L3, been in place for ever and I'm trying to get an output similar to this (below) to find out what ports have been used lately (trying to clean up).
This output is just a show interface on a 2924cxl
FastEthernet0/4 is down, line protocol is down Hardware is Fast Ethernet, address is 0030.8021.0644 (bia 0030.8021.0644) MTU 1500 bytes, BW 0 Kbit, DLY 0 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive not set Auto-duplex , Auto Speed , 100BaseTX/FX ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output 5d17h, output hang never Last clearing of "show interface" counters never
So far all I can find is a show port counters which is not great...
Card is in a WS-C4006 Software, Version NmpSW: 6.3(5)
if the device is performing multilayer switching the stats will be not accurate: that is it should provide you stats only of packets processed by it not the whole traffic processed by L2 supervisor with the assistance of the routing engine.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...