Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

show ip EIGRP topology

Hi people,

I want to know how to interpret properly this command?

What am I supposed to determine from this command?

Regional1 Con0 is now available

Press RETURN to get started!

Regional1>enable

Regional1#show ip eigrp topology

IP-EIGRP Topology Table for AS(222)/ID(192.168.80.33)

Codes: P - Passive, A - Active, U - Update, Q - Query, R - Reply,

r - reply Status, s - sia Status

P 192.168.95.0/24, 1 successors, FD is 2172416

via 192.168.77.34 (2172416/28160), FastEthernet0/0

P 192.168.80.0/24, 1 successors, FD is 2172416

via Connected, Serial0/1

P 192.0.18.0/24, 1 successors, FD is 2172416

via Connected, FastEthernet0/1

P 192.168.77.0/24, 1 successors, FD is 2172416

via Connected, FastEthernet0/0

P 192.168.90.0/24, 1 successors, FD is 2172416

via 192.168.80.34 (2172416/28160), Serial0/1

P 192.168.70.0/24, 1 successors, FD is 2172416

via 192.168.36.14 (2172416/28160), Serial0/0

P 192.168.36.0/24, 1 successors, FD is 2172416

via Connected, Serial0/0

Regional1#

1 REPLY

Re: show ip EIGRP topology

Here's a link that hopefully helps.

http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094613.shtml

HTH and please rate.

114
Views
0
Helpful
1
Replies