Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Show ip ospf database summary area x.x.x.x on Nexus 7K only showing route with lowest cost

On the nexus 7K, when the command show ip ospf database summary area x.x.x.x is run, it is only showing the default route with the lowest cost. The default route cost is configured specifically with two different cost value (cost 2 and 9). Have the same setup with the 6500 but seeing both info from the show ip ospf database but not on the 7K. Is this behaviour inherent to NExus 7? or something else....

akldcb-agg-2# sh ip ospf database summary area 0.0.0.x

       OSPF Router with ID (x.x.x.x) (Process ID 1 VRF default)

               Summary Network Link States (Area 0.0.0.3)

Link ID         ADV Router     Age       Seq#       Checksum

0.0.0.0        

x.x.x.y   332       0x80000373 0x0c99

akldcb-agg-2# sh ip ospf database summary area 0.0.0.x

        OSPF Router with ID (x.x.x.x) (Process ID 1 VRF default)

                Summary Network Link States (Area 0.0.0.3)

Link ID         ADV Router      Age        Seq#       Checksum

0.0.0.0        x.x.x.y  332        0x80000373 0x0c99

569
Views
0
Helpful
0
Replies