Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

show mac-address-table

Hello Guys,

I am facing a strange behavior;

let's say I have a server connected to a Cisco switch , I issue the command "sh mac-address-table" and I can see the mac address of the server.

however, not all the time, sometimes the servers is still connected and functioning, but the mac address is not appearing, I issue the command multiple times and i get the mac address.

have you faced this before? do you know why this is happening?

thx in advanced.

rgrds

3 REPLIES
Blue

Re: show mac-address-table

Hi:

The default flush timer for MAC address entries is 300 seconds. Tt can be reduced to 15 seconds if there is a topology change. STP will flush the MAC address table to hasten convergence by expunging stale entries. If you are running rapid STP, the flush time is even quicker.

See if you are experiencing any changes or instability in your network.

If you just happen to see the entry get flushed and then re-appear, this may be normal if it occurs in a steady and deterministic manner, such as every 300 seconds.

HTH

Victor

New Member

Re: show mac-address-table

When the mac-address is not in the table ping the server from the switch if possible. Then immediately check the mac-address-table again. Does the server mac address show up?

New Member

Re: show mac-address-table

the mac will only be in the table when the server is sending traffic. So if the server is not sending any traffic, then the mac will be flushed by default every 300 seconds. So after 300 sec and still do not see the mac, that could mean the server is not sending traffic.

411
Views
0
Helpful
3
Replies