02-06-2011 08:02 AM - edited 03-06-2019 03:22 PM
hi Experts,
I was troubelshooting an issue with one customer for FEX. I refered some old documentation. It seems that following command is removed from 4.2 code. This command is available in 4.1 code
show platform software satmgr info satport eth 1/5
What is the equivalent command in 4.2 (1) N2 code??
Is it true to say new command would be
show platform software fex info satport ethernet 1/5
Similarly I cannot find any command after "show platform software satmgr ?"
Are this command changed to "show platform software fex ?"
If there a documentation about this??
Solved! Go to Solution.
02-06-2011 08:25 PM
Hi Krunal,
I believe the command you are looking for is:
"show platform software fex info satport ethernet
I also added cisco documentation which show this command being used for fex counters.
search "sh plat soft fex info"
I hope this helps.
Thanks,
Andrew
02-06-2011 08:25 PM
Hi Krunal,
I believe the command you are looking for is:
"show platform software fex info satport ethernet
I also added cisco documentation which show this command being used for fex counters.
search "sh plat soft fex info"
I hope this helps.
Thanks,
Andrew
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: