We have numerous WS-C3524-XL-EN switches througout the network on different subnets. When I run this command on any of the switches it says the following...
CPU utilization for five seconds: 40%/4%; one minute: 38%; five minutes: 38%.
I thought this to be rather high and that it was constant across all of these model switches. We also have some 3550 switches configured the same way with barely any utilization. Does anyone have any ideas?
That is not high for those switches , without anything running and right out of the box it will runn at least 30% . A statement right out of the doc below. A 3550 is a totally different architechure so those will not register the same , they are a L2/3 switch.
" Therefore, it is normal for a 2900XL or 3500XL switch to indicate a CPU utilization value of 30 percent to 50 percent, even under minimal load.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...