10-28-2008 03:01 PM - edited 03-06-2019 02:11 AM
What is the difference between the show service module command output versus th show controllers output? Is one better or more accurate than the other? Are these layer one or two statistics? Thanks.
11-04-2008 09:55 AM
It displays layer 2 statistics. To display the performance report for an integrated CSU/DSU, use the show service-module serial command in privileged EXEC mode. show service-module serial number [performance-statistics [interval-range]]
Displays the CSU/DSU performance statistics for the past 24 hours. This keyword applies only to the fractional T1/T1 module.
To display serial controller statistics. the show controllers serial command also displays configuration information such as the framing, clock source, bandwidth limit, whether scrambling is enabled, the national bit, the international bits, and DSU mode configured on the interface. Also displayed are the performance statistics for the current interval and last 15-minute interval and whether any alarms exist.
For further information click this link
http://www.cisco.com/en/US/docs/ios/interface/command/reference/ir_s3.html#wp1011412
02-19-2009 08:57 PM
Thank you for your response.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: