Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Show Supervisor Backplane Packets Per Second

I am looking for the show command that will show the total packets per second going through the switch. I thought I had the command at one point but am having troubles finding it. Every time I look for back plane utilization, all I can find is the CPU.

1 REPLY

Re: Show Supervisor Backplane Packets Per Second

I don't think I've ever seen pps, but here might be a couple of helpful commands;

6503-1#show platform hardware capacity ?

acl Show QoS/Security ACL capacity

cpu Show CPU resources capacity

eobc Show EOBC resources capacity

fabric Show Switch Fabric resources capacity

flash Show Flash/NVRAM resources capacity

forwarding Show forwarding engine capacity

ibc show IBC resources

interface Show Interface resources capacity

monitor Show SPAN resources capacity

multicast Show L3 and LTL Multicast resources

netflow Show Netflow capacity

pfc Show PFC resources capacity

power Show Power resources capacity

qos Show QoS resources capacity

rate-limit Show CPU Rate Limiters capacity

system Show System resources capacity

vlan Show VLAN resources capacity

| Output modifiers

6503-1#show catalyst6000 ?

all show all Catalyst 6000 information

chassis-mac-addresses chassis MAC address range

switching-clock switching-clock failure recovery mode

traffic-meter current and peak traffic meter reading

| Output modifiers

6503-1#show fabric ?

active crossbar fabric linecard active and backup info

channel-counters fabric channel counters

clear-block clear-block congestion control for fabric channels

drop drop counters for different queues in fabric

errors fabric port errors

status status of crossbar fabric

switching-mode crossbar fabric and system switching modes

utilization fabric port utilization percentage

| Output modifiers

1543
Views
4
Helpful
1
Replies
CreatePlease login to create content