Re: Show vlan id with multiple vlans not working as expected
I've never tried to view them individually as a group like this in the past. I get the same thing on a 2960. If you do a "show vlan" only and then enter, you get the above as you would if you listed them out. It seems like this command, along with listing them out, are for access ports only (remember trunk ports don't show members). If you list the individual vlan, you get back the trunk ports that are members of that vlan. I don't think this is a bug, but by design.
All of the ports in vlan 10 are trunk ports, but notice they don't show up with "sh vlan" or "show vlan id 10,140". I believe this shows access ports only, and specifying the individual will show you the trunk port information.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...