Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

show vlan

Can someone please explain the below output ? Or any link is also fine.

I just know that it shows vlans and their status and ports...  and here there is something more.

And also is there any command to see how many vlans are supported on the particular switch ? Or only found in datasheet.

Thanks in advance.

switch0#show vlan

VLAN Name                             Status    Ports

---- -------------------------------- --------- -------------------------------

1    default                          active    Fa0/1, Fa0/2, Fa0/3, Fa0/4

                                                Fa0/5, Fa0/6, Fa0/7, Fa0/8

                                                Fa0/9, Fa0/10, Fa0/11, Fa0/12

                                                Fa0/13, Fa0/14, Fa0/15, Fa0/16

                                                Fa0/17, Fa0/18, Fa0/19, Fa0/20

                                                Fa0/21, Fa0/22, Fa0/23, Fa0/24

                                                Gig1/1, Gig1/2

2    VLAN0002                         active   

1002 fddi-default                     act/unsup

1003 token-ring-default               act/unsup

1004 fddinet-default                  act/unsup

1005 trnet-default                    act/unsup

VLAN Type  SAID       MTU   Parent RingNo BridgeNo Stp  BrdgMode Trans1 Trans2

---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------

1    enet  100001     1500  -      -      -        -    -        0      0

2    enet  100002     1500  -      -      -        -    -        0      0

1002 fddi  101002     1500  -      -      -        -    -        0      0  

1003 tr    101003     1500  -      -      -        -    -        0      0  

1004 fdnet 101004     1500  -      -      -        ieee -        0      0  

1005 trnet 101005     1500  -      -      -        ibm  -        0      0  

Remote SPAN VLANs

------------------------------------------------------------------------------

Primary Secondary Type              Ports

------- --------- ----------------- ------------------------------------------

switch0#

Regards,

Chandu

Regards, Chandu
1 REPLY
VIP Purple

Re: show vlan

HI Chandu,

To display the parameters for all configured VLANs or one VLAN (if the VLAN ID or name is specified) on the switch thats the reason we use the show vlan command.

How many vlan supported on whcih swicth: these vary on VTP version and many other...

please check this posts and attached pdf.

https://supportforums.cisco.com/thread/2032713

98
Views
0
Helpful
1
Replies
CreatePlease to create content