Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Showing DSCP statistics on Cat 6k interfaces

I would like to confirm that I have DSCP trust end to end on a network.

On a 3750 switch all I need do is:

show msl qos interface Gi1/0/1 statistics

This will list out the number of bytes ingressed/egressed for each DSCP value.

On a 3550 I can configure a port to collect DSCP statistics:

mls qos monitor dscp 48 46 16 10 8 26 24

and then read them with:

sho mls qos int f0/8 statistics

My question is:

How can I get the ingress/egress bytes of a particular DSCP value from a Cat6k port?

1 REPLY
Bronze

Re: Showing DSCP statistics on Cat 6k interfaces

The trust-ipprec and trust-dscp keywords are supported only with a Layer 3 switching engine. 1q4t ports (except Gigabit Ethernet) do not support the trust-ipprec and trust-dscp port keywords. You must configure a trust-ipprec or trust-dscp ACL that matches the ingress traffic to apply the trust-ipprec or trust-dscp trust state.Refer URL

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_7_1/conf_gd/qos.htm#wp1021574

140
Views
0
Helpful
1
Replies
CreatePlease login to create content