Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

simple command help needed

I have a switch on top of a water tower and need to verify what devices are connected to each port on the switch. Is there a command I can use to view IP info of each device connected to the switch? it is a WS-C2955T-12

1 REPLY
bjw Silver
Silver

Re: simple command help needed

You can use show CDP nei detail to find any Cisco CDP enable devices that are connected.

A show mac-address will give you a list of all connected mac-addresses, from that you can go to the default gateway device and discriminate each MAC address from show ip arp commands

From that you'll have MAC-Port#-IP Address

121
Views
0
Helpful
1
Replies
CreatePlease login to create content