cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
286
Views
0
Helpful
1
Replies

Simple NAM Module Config Question

mrashby
Level 1
Level 1

All,

I have a C/D/A architecture. I have 2 WS-SVC-NAM-2 modules. I have one installed in my core 1 6509 switch and the other installed in my core 2 6509. I am trying to configure the module on core 1. My question is since I am routing all throughout the network how do I get the nam module to communicate. Do I have to create a vlan for the NAM module in order to get a default gateway for it. I am just trying to get simply layer 3 connectivity but I can't figure out how to set it up so it has a gateway. I put the gateway in for the NAM as the router since it is the next hop and I got an error message telling me that the IP and gateway have to be in the same subnet.

1 Reply 1

t511820
Level 1
Level 1

Hello mrashby, I have the same question like you. Somebody can help us with this question?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco