hello guys....I have a very simple query please help me to find out:
I have only one IP series 192.168.1.0/24
and there are 4 Routers, 8 Switchs and 8 PCs which need to configured, in each Router there will be 2 Switchs with two FastEthernet port has to be connected and In each Switchs there will be 1 PC. And the Switches configuration has to be default. Please help me to by given the command of the routers with IP addresses.
Yes its basically a testing purpose what we are trying to deploy in a Lab. can u please help me out by given the recommended routing commands... infact I am facing the problem when I am putting the IP address...
when I am putting the ip address on interface0/1 then it says that ip overlapping...
so in this scenario what will be the router command to put the IP address when I was input ip address 192.168.1.1 for FE0/0 then it taking...but when I am putting 192.168.1.2 on FE0/1 its not taking....I just want to know why its not taking and what will be the commands on that scenario...i wants to configure two FE .
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.