Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Simple STP question

hi out there

We are looking for some latency in our net and I am trying to check if our STP implementations is running correctly - we have a simple flat network here and no blocked ports here - just two nx 5010 which are interconnected with two uplinks

A remote site - mirrored setup - with 2 10G dark fiber connections - one for each nx5010 - is connection a DR site. I have split the two sites in two stp domains by enabling bpdu-filter on the vpc between the two sites.

I have been running wireshark on the local segment for some time and see the STP RST ROOT announcement every 2. seconds  - this is probably normal ? I was looking for some alternate root negotiation packets which would cause the mac tables to be flushed - how would they look? I don't see anything but I would just like to know to be sure.

best regards /ti

2 REPLIES
New Member

Simple STP question

Show in the log of the switch if something happen, you will see it. Change if you haven't the priority of your root switch to 0. If you can provide a configuration or output of log, and a jpeg or scenario of your network we can better understand and help you.

New Member

Re: Simple STP question

hi again

We are running (almost) full std config on the STP setup - the only thing I have done with STP is to define a bpdu-filter between the two sites to split it into two STP domains - the rest i default config from the box - I have uploaded a visio drawing which might help

300
Views
0
Helpful
2
Replies