Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Simple Vlan Configuration

I have a 2960 that is connected to a NetGear router for cable modem access and to our corp network. The netgear gives out IP addresses for public access. I have a WAP with two SSIDs. One ID is PUBLIC and tagged as VLAN 8. The other is PRIVATE and untagged.

I have updated my diagram to show what I need to happen. Based on what SSID a user attaches to with there laptop, they have access to the corporate lan or public internet access. I cannot get the ports on the switch to allow this to happen. What needs to be set to get it to work via VLANs. No routing between VLANs is needed.

4 REPLIES
Hall of Fame Super Silver

Re: Simple Vlan Configuration

Hello Ronald,

the port between the C2960 and the access point has to be a trunk port carrying vlan 8 and another vlan x

that vlan has to be the native vlan on the port

int type x/y

desc to access point

switchport

switchport trunk enc dot1q

switchport trunk native vlan x

switchport trunk allowed vlan 8,x

switchport mode trunk

the access point has to associate

SSD1 to vlan 8

SSD2 to vlan x

Hope to help

Giuseppe

New Member

Re: Simple Vlan Configuration

Does the port that the netgear need to be set as trunk or just as Access and VLAN8

New Member

Re: Simple Vlan Configuration

I can get an address from the netgear but I cannot get an address from the corp network DHCP.

New Member

Re: Simple Vlan Configuration

I have the port that the corp DHCP server is on is a trunk port. That is the only setting.

165
Views
0
Helpful
4
Replies
CreatePlease to create content