Simulating the "no QoS" behavior when "mls qos" is issued on 296
Well, I'm going to try... ;-)
Unless I'm wrong, paquets go thru the same circuitry (asics) wheter QoS is activated or not.
Activating the QoS on the switch by just entering "mls qos" reprograms that circuitry and selects default values for various user-configurable parameters (in fact, I am referring to section 2.1.1 of above document).
This would also mean that, when QoS is not activated, another set of (fixed) default values must be in use; let's call that set of values the noqos-set.
Now, let's say I activate QoS on the switch by entering "mls qos" into its config but want to reproduce as nearly as possible the switch's behavior when QoS is not activated. I would thus need to enter various additional QoS-related commands into the config, so as to try to reproduce the noqos-set.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.