Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

SLB using multiple vserver groups to same real servers

I am trying to configure multiple vserver groups to point to the same real servers. According to Cisco TAC you can do this. In the below config the vserver group BAS is workking fine and has been for sometime. The virtual address 10.10.5.15 is to get to webmail to exchange servers so when you webbrowse to the 10.10.5.15 address you get the webmail login, however when you go the new vserver group virtual ip 10.10.10.20 the page times out. I can see hits on the veserver, but the webpage login never appears.

This is my current SLB config.

ip slb natpool CLIENT-NAT 10.10.5.12 10.10.5.12 netmask 255.255.255.0

!

ip slb serverfarm EXCHANGE

nat client CLIENT-NAT

!

real 10.10.5.13

inservice

!

real 10.10.5.14

inservice

!

ip slb vserver BAS

virtual 10.10.5.15 tcp 0

serverfarm EXCHANGE

sticky 86400 group 1

inservice

!

ip slb vserver Mail

virtual 10.10.10.20 tcp 0

serverfarm EXCHANGE

sticky 86400 group 2

inservice

Thanks

120
Views
0
Helpful
0
Replies
CreatePlease to create content