03-25-2008 05:28 PM - edited 03-05-2019 09:58 PM
G'day all
We had power outage and ever since I'm getting terrible network responce from a numnber of our IBM servers that run broadcom network team. Is there any issues that are known or what shoukd I start looking at to try and solve the issue.
The network cards are set to auto speed (1g) and the network ports are as follows
interface GigabitEthernet6/43
switchport access vlan 10
switchport mode access
switchport nonegotiate
speed 1000
duplex full
spanning-tree portfast
spanning-tree guard root
03-25-2008 07:58 PM
Leave the switchports as auto also if the nics are auto this could be causing a problem , you always match each side.
03-25-2008 08:07 PM
I've found it is usually better to hard set one side at least. I've moved the connection to another port on another card and that' OK so it looks like I might have a faulty card. I'm not sure how to diagnose this though.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide