Setup: NAS connected to one Cisco 3560 with 1Gb/s interface. Trunk from 3560 to 6509(a) with 1Gb/s. Trunk from 6509(a) to another 6509(b) with 10Gb/s. One port with 1Gb/s connected to a windows 2008 server.
The 6509 are configured with VRF's, VLAN's and HSRP. One VRF has 2 VLAN's connected. Routing between those VLAN's works fine.
When both the windows 2008 server and the NAS are in the same VLAN, traffic both ways works with good throuput. When the server and NAS are in different VLAN's but same VRF. Trafikk from NAS to server works good, but when we initiate traffic from server to NAS teh speed is reduce with nearly 50%.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...