Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Slow upload in DMVPN

Hi Everyone

Happy New Year!

We have Client they have DMVPN network from 3 offices to Central hub site.

One office has 10MB Wan connection from the ISP to Hub site and it is new setup.

Router port connected to ISP is hard coded as full duplex and speed of 10 as ISP also have  hard coded at their end.

When users did test  from there PC the download speed is upto 8 MB but upload seed is only half MB.

Setup at office is as below

PC---Switch ----Router ---ISP Router.

I checked the CPU utilization on switch and router it is normal.

Wan port has no errors.

Need to know is there any thing i can do on my end to increase the upload speed?

Regards

Mahesh

2 REPLIES
VIP Super Bronze

Slow upload in DMVPN

Hi Mahesh,

Download speed of 8Mb on a 10Mb circuit is not bad.  Regarding your upload speed, talk to your ISP.  Some ISPs with give a lager bandwidth for download then upload.  If you have a contract/SLA with ISP for 10 up and 10 down, then open a ticket with the provider, so they can run some tests on your circuit and send you the results.  Also, make sure your router can handle the speed and it is configured correctly.

HTH

Reza

New Member

Slow upload in DMVPN

Hi Reza,

ISP says all is good from their end.

Here is Router port config that connects to ISP

interface FastEthernet0/0

description <<  INTERNET >>

ip address x.x.x.x

ip access-group 139 in

ip nat outside

ip virtual-reassembly

rate-limit output 496000 93000 186000 conform-action transmit exceed-action drop

ip tcp adjust-mss 1300

load-interval 30

speed 10

here is tcp mss set to 1300 is this ok?

Also there is rate-limit  is this ok?

Any thing i check on my side to make sure all is good?

Regards

MAhesh

180
Views
0
Helpful
2
Replies
CreatePlease login to create content