iSCSI initiators (IP hosts) discover the iSCSI targets to which they may have access.The SN 5428-2 supports two methods of iSCSI target discovery:
?SendTargets mechanism?allows the initiator to use the iSCSI "SendTargets" request to get a list of targets to which it may have access, as well as the list of addresses (IP address and TCP port) on which these targets may be accessed. This is the IETF standard iSCSI target discovery mechanism, and cannot be disabled on the storage router.
?Service Location Protocol (SLP)?provides the storage router with the ability to advertise iSCSI targets to initiators or servers that use SLP. SLP advertisement is enabled by default for all SCSI routing instances. However, the SLP service is disabled by default for the storage router.
No additional configuration is required to support the SendTargets mechanism of iSCSI target discovery. To use the SLP method of iSCSI target discovery, however, you must enable the SLP service on the storage router
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.