Small Business Pro ESW 500 series strict priority queue issue
anyone else run into issues with trying to make queue 1 strict priority?
clearly the DSCP and COS mappings for high priority traffic like VoIP go to queue 1 (DSCP 46 EF, COS 5 for example)
all 4 queues default to WRR queuing. The HTML page will not let me set queue 1 to strict priority without setting queues 2,3,&4 to strict priority. It will only allow strict priority for the following queue combos...
completely opposite to what I'd expect.
I'm not at the office, but this was the same on a 1.0.?.? code and the latest 2.0.3 downloaded.
Anyone else run into this?
Anyone else agree it's an issue?
I'm stuck doing an install for a cust (we resell Cisco) who doesn't have Smartnet, so Cisco won't talk to me (yet). Jeesh.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...