SNMP Community

[jlcarey1usa]

I have an SNMP community string that is incorrect on a Cisco 2811 router. I can't seem to change the snmp-community name. What are the commands to change the name?

[jackthumar]

Hi James,

The commands to change the SNMP community string is as follows.

Router(config)#no snmp-server community xxxx

where xxxx is current community string

Router(config)#snmp-server community yyyy

where yyyy is the new community string.

Pls follow the below mentioned link. It will give you a better understanding.

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094aa4.shtml#modifysnmp

*Pls Rate if it Helps*

Rgs,

Jack

[jlcarey1usa]

Jack,

Thanks. I was able to change the string and enter the new community name. I didn't realize it was so easy...