Kindly let me know what all SNMP commands are useful for typical 6500 series swicth used in datacenter. I wish to configure this switch for sendinig SNMP alerts in case of 'module down' or 'module power down', but I do not want to monitor the link down/up of each and every switchport (just want to monitor modules). Kindly let me know how can it be done?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...